Hi, I am using VPhot for the first time and ran into a problem. I am using AAVSONet images and ran a time series. I picked the target, comp and check stars and gave the sequence a name, which I selected.
The program seemed to run, and is giving me some data like air mass, SNR ratios for the check and comp stars, etc but there is no data for the star magnitudes. When I click on each star (target, comp, check) a table comes up showing the star is not detected in all the images. What am I doing wrong?
- Are the target and comps clearly visible on the images? IOW, is the exposure sufficient. Was it cloudy?
- In the comp table at bottom of results page, are the comp stars checked as active?
- Share some images to me (MZK). Note the ‘Share’ link near top of image list page.
- In future, start a new topic rather than posting in the top ‘Welcome’ post.
Ken
Thanks for helping me, Ken. Yes the target and comps are clearly visible. I think I am doing something wrong in creating the sequence, maybe. I will share some screenshots with you.
Michelle
Actually, I can’t figure out how to use the “share” link to share screenshots so I will email them to you. Sorry I am such a dunce with using this forum; I also could not find how to start a new topic.
I was able to run these images on AIJ, but I would like to learn how to use VPHOT.
Below, I am attaching the screenshots of what I am getting when trying to run a time series on WASP 52
Did you choose comps from the Catalogs/Load AAVSO Comps Stars?
Usually magnitude zero indicates that your comp stars don’t have magnitudes for that filter.
Most exo planets fields have no AAVSO comps.
So when you use VPHOT or AIJ for photometry, you would want to pick your comps, then go find the best magnitude estimate that you can find for you picked comps.
Ray
I used the AAVSO photometry table and finder chart for WASP-52, see attached
WASP-52 photometry chart.docx (18.1 KB)
The photometry chart does give magnitudes and B-V values for these stars…
Michelle:
You selected your own comps (Star 1,… etc.) based on the Chart. Not the normal procedure. VPhot does it automatically. Ray mentioned clicking “Catalog” and then “AAVSO Comps”. These comps will show up automatically on the image. You can select which ones to use.
You can also select Targets under “Catalog”.
HTH, Ken
Did you find the ‘Share’ link on your Available Images page?
Ken
OK, thanks! That helped. Now it is showing
the data for the target and check star, and some of the data for the comp star but not the magnitude or light curve for the comp star. Why? I am attaching a screen shot of the results page.
-
Since you only selected one comp star, there is no plot of that comp star since it was not measured against another comp star(s). The chart does not plot the instrumental magnitude like AIJ BUT the calculated standard magnitude. If you selected a second comp (try that) you would see a plot of the comps compared to each other. In the case of only one comp you get nothing plotted. Just normal practice in vphot.
-
BTW, your target is named Star 1. Did you click targets under Catalog? Did it list/plot no targets (variable stars)? That may be true since WASP-52 is not a variable star but a transit host. Just a little wrinkle of definition in the VSX catalog?
-
BTW, you can edit the name of Star 1 if you click on it, and then save sequence.
Ken
PS: There is a VPhot User’s Guide.
Thanks, Ken! I did read the User’s Guide which is good, but it did not go into detail on how to create the sequence.
Thanks to your help, I was able to get the time series to work and generated an AAVSO Report and submitted it.






